Product manual

20
The following table describes the Bus Status LEDs for 3000S SCSI RAID
controllers.
Installing I
2
O Drivers
Your new Adaptec controller uses I
2
O drivers supplied by Adaptec or
your operating system vendor. This section discusses driver and
operating system installation when using Adaptec controllers. After
you install the operating system, you can install Storage Manager or
Storage Manager Pro. These applications are available for the platforms
listed in Installing Adaptec Storage Management Software on page 32.
TERMPWR-A
TERMPWR-B
These LEDs are lit when termination power is
supplied by the controller for the respective
channels.
TRMEN-A
TRMEN-B
These LEDs are lit when termination is enabled
on the controller for the respective channels.
TRMENHD-A This indicates the upper 8 bits of the A channel
(Bus 0) are terminated to support an 8-bit bus
segment. This LED is lit when the High-Only
option is selected for bus termination.