Installation guide

D-3
Controller Reset Procedures
4 When you see the Adaptec splash screen, click Create Driver
Disk. Then, click the appropriate menu option.
5 Insert a floppy disk and click OK. The system creates the
bootable SMOR disk.
6 Remove the Adaptec RAID Installation CD and the driver floppy
disk.
7 Shut down the system.
8 If necessary, reinstall the controller in your system.
Now, to reset the controller firmware, BIOS, and SMOR, perform the
following tasks:
1 Install a jumper on flash mode 0 jumper connector. For the
location of the jumper connector, refer to Appendix A.
2 Insert the SMOR boot disk and boot the system. SMOR starts.
3 Use SMOR to flash the controller firmware.
4 Shut down the system.
5 Remove the jumper you installed in Step 1.
6 Remove the SMOR boot disk.
7 Reboot the system from the SMOR boot disk. If the system
restarts normally, the controller can now be configured using
SMOR or Storage Manager.
8 Use SMOR to flash the controller BIOS and SMOR images.
If the system fails to restart, call Adaptec Technical Support.