Installation guide

4-3
Installing Storage Management Software
Installation Prerequisites
The prerequisites for installing Storage Manager Pro are that you
have already installed the following:
■ Adaptec RAID controller and drives. Refer to Chapter 2,
Installing Your Controller.
■ Controller driver. Refer to Chapter 3, Installing the Driver.
Storage Manager Pro requires approximately 60 MB of free disk
space during the installation process. After the installation is
complete the application uses approximately 20 MB of disk space.
Note: When you start Storage Manager Pro, you will be
prompted to provide a user ID and password. The default
user ID is administrator, the default password is adaptec. For
details, refer to the Storage Manager Pro User’s Guide.
Note: If you already have Storage Manager Pro installed on
your computer, you must uninstall it before reinstalling it.
To uninstall Storage Manager Pro, refer to the Adaptec
Storage Manager Pro User’s Guide.
Windows
When you install Storage Manager Pro for Windows, you
automatically install Java Runtime Environment (JRE) 1.1.8, which is
required to run Storage Manager Pro. This does not conflict with any
other version of the JRE or Java Development Kit (JDK) you have
installed.
Note: Do not install Storage Manager Pro on a network drive,
because Storage Manager Pro runs as a Windows NT/2000
service and services do not have network access rights.
To install Storage Manager Pro on Windows
1 If you are using a Windows 2000 or Windows NT system,
verify that you have administrator privileges.