Installation guide

3-28
Adaptec RAID Installation Guide
4 To run the installpkg utility, type installpkg -d disk/.
SCO UNIX reads the disk and prompts you to enter the
package name to be installed.
5 Type dpti4 for Open Desktop 3.x and dpti5 for SCO
OpenServer 5.x.
6 After the package is installed, rebuild the kernel.
7 Restart the system.
8 Install the new kernel.
9 Add devices to the controller.
Adding the Controller to an Existing UnixWare 7 System
In this scenario, you are adding an Adaptec RAID controller to an
existing UnixWare 7 system. To install the driver
1 Install and configure your Adaptec RAID controller and hard
drives according to the instructions in Chapter 2.
2 Download the latest I
2
O supplement for UnixWare 7 from the
SCO Web site—it should be
ptf7066c or higher.
3 Uncompress the PTF file you downloaded in Step 2 and move
the file to the
/tmp directory.
4 Use the pkgadd utility to install the I
2
O supplement by typing:
pkgadd -d /tmp/ptf7066c
5 Follow the on-screen prompts to install the SCO UnixWare I
2
O
supplement.
6 Shutdown and reboot the system.
Note: Upon restarting, several warning messages may
appear and scroll off the screen quickly. These will not occur
after diskadd is run and can be ignored.
7 Use the diskadd utility to add drives or arrays that are attached
to an Adaptec RAID controller.