Installation guide

3-26
Adaptec RAID Installation Guide
SCO UNIX
The Adaptec RAID Installation CD contains a driver for each version
of SCO. You use the CD to create driver disks. Two disks are
required to store all of the drivers. To create the driver disks
1 Start up the system from the CD and select Create driver disks .
2 Select the SCO operating system you are using.
3 Insert floppy disks when prompted until all drivers are copied.
Alternatively, you can use the
dd command to copy the disk images
directly from the CD to a floppy disk. The following disk images are
on the Adaptec RAID Installation CD:
Installing the Driver in a New OpenDesktop 3.x System
In this scenario, you are installing SCO UNIX OpenDesktop 3.x on a
single drive or array group. To install the driver
1 Start up the system with the N1 disk.
2 At the boot prompt, type
defbootstr link=dpti4
3 When prompted for the SCO BTLD disk, insert the driver disk
you created earlier.
4 Insert the N1 or Boot Disk again when prompted.
5 Insert the N2 disk when prompted. In the Hardware Roster,
the following line should appear:
% adapter type=dpti ha=0 id=7 channel=0, PCI
6 Continue the installation according to the SCO documentation.
Driver Storage Manager and RAIDUTIL
Open Desktop 3.x /packages/
Open_Desktop_3/image
/packages/
Open_Desktop_3/apps/sm
OpenServer 5.x /packages/
Open_Server_5/image
/packages/
Open_Server_5/apps/sm