Installation guide

3-25
Installing the Driver
12 Select Edit startup.ncf.
13 Install the latest support pack for NetWare 5.
Installing the Driver in an Existing NetWare 5 Server
In this scenario, you are integrating an Adaptec RAID controller into
an existing Novell NetWare 5 server as a secondary controller. To
install the driver
1 Upgrade your NetWare server to the minimum patch level
specified by Novell.
2 Create a driver floppy disk using the Adaptec RAID Installation CD .
To create the disk
a Insert the Adaptec RAID Installation CD in your drive and a
blank floppy disk in the floppy disk drive.
b Copy all the files in \packages\netware\5.x\driver to the floppy
disk.
c Remove the Adaptec RAID Installation CD and the driver
floppy disk.
3 Shutdown the server.
4 Install and configure the Adaptec RAID controller as a
secondary controller according to the instructions in Chapter 2.
Note the slot occupied by the controller, you will need this
information later in the install process.
5 Start up the server. During startup, press Ctrl+A to start
SMOR. Use SMOR to create the RAID. For details, refer to
Using SMOR on page 2-10.
6 Start NetWare and insert the driver disk you created in Step 2.
7 When the console prompt appears, type load nwconfig and
press Enter.
8 Select Driver.
9 Select Disk Driver.
10 Install i2opci.nlm and bkstrosm.ham. Specify a:\ as the location
for the files.