Installation guide

3-16
Adaptec RAID Installation Guide
22 If you system contains multiple Adaptec RAID controllers,
repeat Steps 14 through 21 for each controller. The system
should ask you to reboot when this action is completed.
23 The Device Manager should now show an Adaptec I
2
O RAID
Host Adapter in the SCSI and RAID Controllers section.
24 Optional: Using a text editor, remove the following entries from
your
config.sys file:
device=i2oddl.sys
device=dptcdrom.sys
25 Optional: Using a text editor, remove the mscdex entry from
your
autoexec.bat file. When you complete the installation
procedure, these
config.sys and autoexec.bat file entries may no
longer be needed.
Adding the Controller to an Existing Windows 95/98/Me
System
In this scenario, you are adding an Adaptec RAID controller to an
existing Windows 95/98/Me system. To install the driver
1 Install and configure your Adaptec RAID controller and hard
drives according to the instructions in Chapter 2.
2 Start up the system. During startup, press Ctrl+A to start
SMOR. Use SMOR to create the RAID. For details, refer to
Using SMOR on page 2-10.
3 Restart the system.
4 If Windows prompts for a driver to support a PCI card, go to
Step 11.