Installation guide

3-13
Installing the Driver
11 During one of the device detection boot processes, Windows
identifies a PCI Card device. Click Next and display the list of
drivers from a specific location.
Note: If you are not prompted for a PCI card or the Device
Manager shows PCI Card with a yellow exclamation mark in
the Other Devices list, you might need a patch so that your
motherboard chipset recognizes multifunction bridge
controllers. Contact your motherboard vendor and apply
the patch. After the patch is installed and the system is
restarted, Windows repeats the device discovery process. If
you are installing the operating system, go back to Step 11
and continue the procedure. If you are adding an Adaptec
RAID controller to an existing system, go to Step 6 on
page 3-17 and continue with the procedure.
12 When prompted, insert the driver disk you created (page 3-11)
and select Have Disk. The system restarts.
Note: If more than one Adaptec RAID controller is installed
in the computer, repeat Steps 11 and 12 for each controller.
13 Open the Device Manager. Select the SCSI and RAID
Controllers icon. The Device Manager should now show an
Adaptec I
2
O RAID Host Adapter.
14 Optional: Using a text editor, remove the mscdex entry from
your
autoexec.bat file. When you complete the installation
procedure, these
config.sys and autoexec.bat file entries may no
longer be needed.