Installation guide

3-10
Adaptec RAID Installation Guide
d When you see the Adaptec splash screen, click Create
Driver Disk. Then, click the appropriate operating system.
e Insert a floppy disk and click OK. The system creates the
driver disk.
2 Shut down the system and remove the Adaptec RAID
Installation CD and the driver floppy disk.
3 Restart the system and open the Control Panel. Click the SCSI
Adapters icon. Then select the Drivers tab and click Add.
4 Insert the driver disk you created in Step 1 and then click Have
Disk.
5 Select Adaptec I
2
O RAID Host Adapter Driver for NT 4.0.
6 After the driver is loaded, shut down the system.
7 Install and configure the Adaptec RAID controller and hard
drives according to the instructions in Chapter 2. Leave the
existing controller installed.
8 Start up the system.