Installation guide

2-7
Installing Your Controller
From the side view shown below, you can see that the module is
placed into the socket at an angle. Then, press the module into place
until the metal clips click into the sides of the module and holds it
securely.
Seating the Module – Adaptec 2400A/2100S/3210S/3410S Only
Holding the circuit board and module by the edges, slide the
module into the socket as shown below. Refer to Appendix A for the
location of the socket.
Press the socket into place and press the white plastic clips against
the module until they hold the module securely.
Finishing up – All Models
To confirm that the modules are properly installed
1 Insert the RAID adapter back into the system.
2 Start SMOR.
3 Select the controller to display the amount of cache memory
reported. The amount of cache reported is always 16 MB less
than what you actually installed.