Installation guide
2-6
Adaptec RAID Installation Guide
Installing Additional Cache Memory
Adaptec RAID controllers can be upgraded with additional cache
memory. See Cache Memory Module on page 1-12 for additional
information about memory modules for cache memory.
To install cache memory modules
1 Ground yourself and take appropriate ESD precautions.
2 If necessary, power down your system and remove the RAID
adapter.
Note: Adaptec 3200S/3210S/3400S/3410S with battery backup
module only—Remove the battery backup module before
installing or removing cache memory.
3 Proceed to the appropriate section for your controller:
■ Seating the Module – Adaptec 3200S/3400S Only on page 2-6.
■ Seating the Module – Adaptec 2400A/2100S/3210S/3410S Only
on page 2-7.
Seating the Module
–
Adaptec 3200S/3400S Only
Holding the circuit board and module by the edges, slide the
module into the socket as shown below. Refer to Appendix A for
socket locations.