User guide

Snap Server Connectors and Controls
6 Snap Server 110/210 User Guide
Snap Server Connectors and Controls
The Snap Server 110 and 210 have the following connectors and controls.
2
2
1
3
4
5
6
7
8
10
10
11
11
9
Connector/Control Description
1 Power Button Press the Power Button to turn the Snap Server ON and OFF.
2 Reset Button Use the Reset Button if you cannot access the Administration Tool
and you need to perform a limited reset to defaults.The Reset
Button is accessed by inserting a paper clip end or small tool into
the hole to the right of the Power Button when the server is fully
booted and running normally.
3 Power LED The Power LED indicates whether power to the Snap Server is ON
or OFF.
• Solid green = Server is ON
• Off = Server is OFF
4 Status LED The Status LED indicates whether the server is operating normally.
• Blinking green = System is operating normally
• Blinking amber = Thermal or other system problem
5 Network LED The Network LED indicates whether the server is connected to the
network.
• Solid green = System is active and connected to network
• Off = Port is disconnected or the Ethernet cable is not connected
or linked to an active switch
6 Disk LED The Disk LED indicates the status of your disk drive.
• Blinking green = Disk drive is active
• Solid amber = Disk drive error
• Off = No disk drive activity