Instruction manual

Need Help with the Remote Control?

Check these common trouble spots:

■ Are you using the correct remote control, the one that was

included in your Adaptec AVC-3610 kit?

■ Do the remote control batteries need to be changed?

■ Is there something blocking the line-of-sight between the

remote control and the IR receiver on the Adaptec AVC-3610?

■ Are all the cables properly connected to and from the Adaptec

AVC-3610?

■ Does the Status Light flash red briefly when you try to use the

remote? If not, see The Adaptec AVC-3610 isn’t receiving the remote

control signal., on page 33.

■ If you have a set-top box:

■ Is the set-top box powered on?

■ Is the IR blaster cable connected properly?

■ Does the remote control work with the Media Center

software but not change channels?

Reconfigure the Media Center software settings for your

set-top box. In Media Center,

select Settings, then select

General > Media Center Setup > Run Media Center

Setup Again.

■ Close the Media Center software, then restart your computer

and open Media Center again.

Note: See also, The Adaptec AVC-3610 isn’t receiving the remote

control signal. on page 33