Instruction manual

17
2 Connect the Adaptec AVC-3610 to your set-top boxes, shown in
the Figure in Step 1 on page 16 as Set-top Box (A) and Set-top Box
(B).
a
Connect an RF coaxial cable from the TV1 jack on th e
AVC-3610 to the TV Out port on Set-top Box (A) .
b Connect an RF coaxial cable from the TV2 jack on the
AVC-3610 to the TV Out port on Set-top Box (B) .
Caution: Be sure not to plug an RF coaxial cable into the FM
tuner jack.
To improve video quality, you can use S-Video cables or
composite video cables instead of RF coaxial cables to make these
connections. See pages 18 to 21 for instructions.
3 Use two RF coaxial cables to connect the TV In ports on your
set-top boxes to the cable splitter.
4 Connect an RF coaxial cable from the cable splitter to your
TV
wall jack.
5 Connect IR blaster cables from the Adaptec AVC-3610 to your
set-top boxes. You must connect IR blaster cables to be
able to change channels.
a Plug an IR blaster cable into the IR 1 port on the Adaptec
AVC-3610.
Then, peel the protective paper off the emitter end of the
cable and adhere it over, or as close as possible to, the
infrared lens of Set-top Box (A).
b Repeat Step a to connect the IR 2 port on the Adaptec
AVC-3610 to Set-top Box (B).
6 Continue with Completing the Setup on page 25.
!