User`s guide

3-31
Storage Manager
Saving the Subsystem Configuration
The Storage Manager File menu has the following options:
Note: If you reset the NVRAM on the controller, any changes
to your controller parameters return to the factory defaults.
Write-through Writes all data to disk for each Write command
before Command Complete status is returned
to the host. The data can also be cached for
subsequent read commands.
Defaults Click to revert to the default setting.
Cancel Click to exit this window without saving
changes.
OK Click to exit with changes.
Read System
Configuration
Reads the current hardware configuration. Any
current changes not saved are lost.
Set System
Configuration
Saves changes that you made to the storage
subsystem configuration. If any arrays have
been created or modified, this action causes the
controller to start build operations for the new
arrays.
Load Configuration
File
Loads a previously saved configuration into
Storage Manager and apply it to the current
hardware.
Save Configuration
File
Saves the current configuration, or any changes
to that configuration, to a file for later use.
Allows storage subsystems to be configured for
other machines with like drives.
Combined RAID SW-UG.book Page 31 Monday, September 9, 2002 1:25 PM