User`s guide

3-15
Storage Manager
1 Select the Create Array Group button. The Select Array Type
window appears, as shown in Figure 3-6.
Figure 3-6 Select Array Type Window
2 Select the desired Fault Tolerance: Drive fault tolerance
(RAID 1 or 5) or No fault tolerance (RAID 0).
3 Select the desired Optimization: Optimize for Capacity
(RAID 5) or Optimize for Performance (RAID 1).
4 As you make your selections, the Chosen Array Parameters
change to indicate which RAID level and stripe size best fit your
selection.
5 You can customize the RAID level and stripe size defaults by
selecting the Override button.
6 Click Continue to select the drives you want to use. The Logical
Configuration View window appears with the caption
Choosing Drives for Array (RAID n), where n is the RAID level
chosen. Select the drives you want to use in the array group as
follows:
a To add drives
■ Click each drive to be added. A green check mark
indicates that a drive is selected.
■ Click Include Drive to add the marked drives to the new
array group. You may need to scroll the window to view
the array group.
b To remove drives
Combined RAID SW-UG.book Page 15 Monday, September 9, 2002 1:25 PM