User`s guide

2-20
Adaptec Storage Management Software User’s Guide
Setting the Configuration
There are two configuration options on the File menu:
■ Read System Config—Causes SMOR to rescan to detect any
changes in hardware configuration or status. Any changes that
have been made and not saved are lost. This operation is run
automatically when SMOR is started.
■ Set System Config—Causes SMOR to save changes that have
been made to the storage subsystem configuration in the
controller memory. If any array groups or multilevel RAIDs
have been created or modified, this operation causes the
controller to initiate a build operation on the new groups.
Array Operations
This section describes how to use SMOR to create arrays and
multilevel RAIDs, delete arrays, assign hot spare drives, and
rebuild an array.
Creating an Array
To create an array, follow these steps:
1 Select RAID > Create. The RAID Type window appears as
shown in Figure 2-9.
Figure 2-9 RAID Type Window
Combined RAID SW-UG.book Page 20 Monday, September 9, 2002 1:25 PM