User`s guide

2-14
Adaptec Storage Management Software User’s Guide
Boot Enable
This option enables you to modify the boot process for systems
with multiple peripheral controllers in cases where the controller
BIOS does not provide effective or appropriate default operation.
This setting is enabled by default.
Disable this setting and the controller can not be used as a boot
device.
Bus Configuration Tab
This tab enables you to modify the hardware parameters for the
highlighted controller bus; it appears when you highlight a device
in the Tree View, as shown in Figure 2-6.
Figure 2-6 Bus Configuration Tab
Default resets the parameters on this tab to their default values.
Controller Parameter Default Available Settings
ID 7 SCSI: 0 – 6
Type As reported N/A
Width As reported N/A
Transfer Rate Maximum allowed
for the controller
Ultra320, Ultra160, Ultra2,
Ultra, FAST, 8, 5
Asynchronous
Termination On On, Off, High Only
Bus boot enable Enabled Enabled, Disabled
Combined RAID SW-UG.book Page 14 Monday, September 9, 2002 1:25 PM