User`s guide

2-13
Storage Manager on ROM
Note: Adaptec RAID controllers report a cache size 16 MB less
than the total installed memory value because the controller
uses 16 MB as processor RAM. Controllers will report the
amount of cache RAM available.
Configuration Tab
The Configuration tab for a controller displays internal settings for
that controller, as shown in Figure 2-5.
Figure 2-5 Configuration Tab
Select Default to reset the parameters on this tab to their default
values.
Mem Address, IRQ
The values in the Mem Address and IRQ fields may be needed
when you configure your operating system. These fields are read
only.
PCI MWI Enable
Do not change this setting unless instructed to do so by Technical
Support.
Combined RAID SW-UG.book Page 13 Monday, September 9, 2002 1:25 PM