User`s guide

4-9
RAIDUTIL Command Line Utility
Hot Spare Control
-h Create hot spare drive
This switch creates one or more stand-alone hot spare drives. The
drives must physically exist and may not contain any logical drive
segments. Reboot your system after creating hot spare drives to
ensure they are recognized correctly.
raidutil –h d0b0t15d0
Makes ID 15 on bus 0 of controller 0 a hot spare.
-H Delete hot spare drive
This switch deletes one or more stand-alone hot spare drives. The
capacity is returned to unassigned space.
Specify the hot spare drives by the device address. Commas must
be used to separate drive addresses. Specify all to delete all stand-
alone hot spare drives.
Combined RAID SW-UG.book Page 9 Monday, September 9, 2002 1:25 PM