Installation guide
C-3
Controller Reset Procedures
RAIDUTIL
a Start the system in DOS mode.
b Go to the folder having the RAIDUTIL program
c Enter the following command: RAIDUTIL -F
3 Remove the jumper you installed in Step 1.
4 Restart the system from the SMOR start floppy disk. If the
system restarts normally, the controller can now be configured
using SMOR or Storage Manager.
5 Use SMOR.exe to flash the controller BIOS and SMOR images.
If the system fails to restart, call Adaptec Technical Support.
R2N2 RAID IG.BOOK Page 3 Monday, September 9, 2002 12:01 PM