Installation guide

3-6
Adaptec SCSI RAID 2010S/2015S Installation Guide
4 Start Windows 2000/XP. Windows launches the Found New
Hardware Wizard, which searches for the controller.
5
Insert the driver disk you created at the beginning of this chapter ,
select it, and click Next.
6 Click Next in the succeeding two windows that appear. Follow
the on-screen instructions to complete the installation.
7 Reinstall any applications or data that had been backup up.
WindowsNT4.0
The following sections describe procedures for installing the
Adaptec ZCR controller with Windows NT:
■ Installing the Driver in a New System on page 3-6
■ Installing the Controller in an Existing System on page 3-7
Caution: When adding a ZCR controller to an existing system,
backup all data from system drives prior to the installation. If
the boot device is connected to one of the on-board SCSI
channels, or you plan to use a RAID array as a boot device,
the operating system will need to be reinstalled after
installing the ZCR controller.
Note: The Microsoft I
2
O Operating System Module (OSM)
does not support the Adaptec ZCR controllers.
Installing the Driver in a New System
In this scenario, you are installing an Adaptec ZCR controller and
Windows NT 4.0 in a new system.
Note: If Windows NT is to coexist with another operating
system, the other operating system must be installed before
you install Windows NT.
!
R2N2 RAID IG.BOOK Page 6 Monday, September 9, 2002 12:01 PM