Installation guide

2-1
2
Installing Your Controller
In this Chapter
Configuring SCSI Devices
When configuring devices for Adaptec ZCR controllers, you may
need to:
■ Decide how to position drives on the SCSI bus.
■ Select cables.
■ Enable or disable SCSI termination.
■ Set the SCSI IDs.
Note: SCSI drives should, in general, not be reformatted.
However, if your SCSI drive was formatted to a sector size
other than 512 bytes, you must reformat the drive before you
can use it in a RAID. Refer to the Adaptec Storage Management
Software User’s Guide for details.
Configuring SCSI Devices 2-1
Installing the Controller 2-5
Creating an Array Using SMOR 2-6
Determining the Booting Controller 2-7
R2N2 RAID IG.BOOK Page 1 Monday, September 9, 2002 12:01 PM