Fast Track 2+2/386 2000 Series Drive-Thru Timer System, User Guide

SECTION 2 - OPERATION 2-9
PHASE RESEARCH
USER GUIDE
SECTION 2 - OPERATION
2-7 Thermal Printer
The Thermal Printer prints reports and logs significant events that occur during the Timer’s
operation, both automatically as scheduled and manually as desired.
The printer uses special thermal paper tape, designed to print only on the side facing out on the
roll. The serrated edge of the paper exit slot helps you to neatly tear off reports.
When the paper tape’s edges begin to turn pink, it is time to load a new roll. To do so:
PRINTER
RESET
BUTTON
PAPER ROLL
HOLDER
POINT
L
OADING PROCEDURE :
1
2
3
4
5
6
1
2
3
4
Openprinter door.
Placeroll in holder sothat printed instructions
faceyouupsidedown.
Cut paper sothat itcomes to a point asshown.
Insertpoint of paper into topof printer until
point comes throughfront.
Carefully pull point of paper directlytoward top
of unit untilabout 6inches isfed through.
Feedpaper completely through printer door
and close andsecure door.
Carefully cut paperwhere it enters printer.
Taking care notto put stress on printer parts,
pull remaining paper fromfront ofprinter. Pull
Toward top of unit.
USEANY DEVICE(SCISSORS,
SCREWDRIVER, POINTED OBJECT)TO
REMOVE PAPER.
Reset printer by pressing the PRINTER
RESETBUTTON. Printheadwillcycle
back and forth.
Repeatthe loading procedure.
CUT PAPER - DONOT FOLD
DO NOT
IF PAPER JAMS:
T
O RESET PRINTER:
1
T
heprinter hasa safety shutoff featureto
protect the printer from heatdamage.
Reset printer by pressing the PRINTER
RESETBUTTON. Printheadwillcycle
back and forth.
IMPORTANT: OPERATOR-CAUSED DAMAGE TO THE PRINTER OR MISUSE WILL VOID THE WARRANTY. TAKE CARE WHEN
REMOVING PAPER JAMS, LOADING PAPER, ETC., TO FOLLOW ALL DIRECTIONS (BELOW) TO AVOID MISUSE
OR OTHERWISE HARM THE PRINTER.