User`s guide
Table Of Contents
- About This Guide
- Kit Contents and System Requirements
- About Your RAID Controller
- Standard RAID Controller Features
- Adding Enhanced Features
- Adding a Battery Backup Module
- Upgrading the Controller Firmware
- About the Adaptec 3085
- About the Adaptec 3405
- About the Adaptec 3805
- About the Adaptec 31205
- About the Adaptec 31605
- About the Adaptec 4000
- About the Adaptec 4800SAS
- About the Adaptec 4805SAS
- About the Adaptec 2420SA
- About the Adaptec 2820SA
- About the Adaptec 2130SLP
- About the Adaptec 2230SLP
- Getting Started
- Installing the Controller and Disk Drives
- Creating a Bootable Array
- Installing the Driver and an Operating System
- Installing the Driver on an Existing Operating System
- Managing Your Storage Space
- Solving Problems
- Introduction to Serial Attached SCSI
- Understanding RAID
- Using the Adaptec RAID Configuration Utility
- Using the Array Configuration Utility for DOS
- Using the Adaptec Flash Utility
- Adaptec Serial Controller LED and I2C Connector Reference
- Adaptec 2420SA Activity LED and I2C Connector Specification
- Adaptec 2820SA Activity LED and I2C Connector Specification
- Adaptec 3085 LED and I2C Connector Specification
- Adaptec 3405 LED and I2C Connector Specification
- Adaptec 3805 LED and I2C Connector Specification
- Adaptec 31205 LED and I2C Connector Specification
- Adaptec 31605 LED and I2C Connector Specification
- Adaptec 4800SAS LED and I2C Connector Specification
- Adaptec 4805SAS LED and I2C Connector Specification
- Safety Information
- Technical Specifications
- Index
7
Installing the Driver and an
Operating System
In this chapter...
Before You Begin .................................................................................................................... 49
Creating a Driver Disk ........................................................................................................... 49
Installing with Windows ........................................................................................................ 50
Installing with Red Hat Linux ............................................................................................... 50
Installing with SUSE Linux.................................................................................................... 51
Installing with NetWare .........................................................................................................51
Installing with OpenServer .................................................................................................... 52
Installing with Solaris............................................................................................................. 52
Installing with UnixWare ....................................................................................................... 53
Installing with VMware ......................................................................................................... 53
Installing with FreeBSD .........................................................................................................54
This chapter explains how to install your Adaptec RAID controller driver and an operating
system onto a bootable array (see page 43).
To install the driver on an existing operating system, see page 55.