User`s guide
Table Of Contents
- About This Guide
- Kit Contents and System Requirements
- About Your RAID Controller
- Standard RAID Controller Features
- Adding Enhanced Features
- Adding a Battery Backup Module
- Upgrading the Controller Firmware
- About the Adaptec 3085
- About the Adaptec 3405
- About the Adaptec 3805
- About the Adaptec 31205
- About the Adaptec 31605
- About the Adaptec 4000
- About the Adaptec 4800SAS
- About the Adaptec 4805SAS
- About the Adaptec 2420SA
- About the Adaptec 2820SA
- About the Adaptec 2130SLP
- About the Adaptec 2230SLP
- Getting Started
- Installing the Controller and Disk Drives
- Creating a Bootable Array
- Installing the Driver and an Operating System
- Installing the Driver on an Existing Operating System
- Managing Your Storage Space
- Solving Problems
- Introduction to Serial Attached SCSI
- Understanding RAID
- Using the Adaptec RAID Configuration Utility
- Using the Array Configuration Utility for DOS
- Using the Adaptec Flash Utility
- Adaptec Serial Controller LED and I2C Connector Reference
- Adaptec 2420SA Activity LED and I2C Connector Specification
- Adaptec 2820SA Activity LED and I2C Connector Specification
- Adaptec 3085 LED and I2C Connector Specification
- Adaptec 3405 LED and I2C Connector Specification
- Adaptec 3805 LED and I2C Connector Specification
- Adaptec 31205 LED and I2C Connector Specification
- Adaptec 31605 LED and I2C Connector Specification
- Adaptec 4800SAS LED and I2C Connector Specification
- Adaptec 4805SAS LED and I2C Connector Specification
- Safety Information
- Technical Specifications
- Index
Chapter 5: Installing the Controller and Disk Drives ● 40
2 Use internal SAS or mini-SAS cables to attach the disk drives to the controller.
3 When all internal disk drives have been installed and attached to the controller, close your
computer cabinet, reattach the power cord, then continue with Connecting External
Devices on page 42.
Connecting to a System Backplane
In a backplane connection, disk drives and SAS cards are attached to and communicate with
each other through a system backplane.
The number of disk drives is limited to the number of slots available on the backplane. Some
backplanes have embedded SAS expanders and can support up to 128 end devices. (For more
information about backplane and expander connections, see page 72.)
1 Connect one or more internal SAS or SATA disk drives to the backplane. (Refer to your
system’s documentation for more information.)
2 Use an internal SAS cable to connect the controller to the backplane.
SAS/SATA
disk drives
Single-port connector
SAS fan-out cable
4-wide internal SAS connector
External SAS connector
External SAS cable
SAS/SATA
disk drives
Single-port connector
4-wide internal SAS connectors
SAS to SATA fan-out cable