User`s guide
Table Of Contents
- About This Guide
- Kit Contents and System Requirements
- About Your RAID Controller
- Standard RAID Controller Features
- Adding Enhanced Features
- Adding a Battery Backup Module
- Upgrading the Controller Firmware
- About the Adaptec 3085
- About the Adaptec 3405
- About the Adaptec 3805
- About the Adaptec 31205
- About the Adaptec 31605
- About the Adaptec 4000
- About the Adaptec 4800SAS
- About the Adaptec 4805SAS
- About the Adaptec 2420SA
- About the Adaptec 2820SA
- About the Adaptec 2130SLP
- About the Adaptec 2230SLP
- Getting Started
- Installing the Controller and Disk Drives
- Creating a Bootable Array
- Installing the Driver and an Operating System
- Installing the Driver on an Existing Operating System
- Managing Your Storage Space
- Solving Problems
- Introduction to Serial Attached SCSI
- Understanding RAID
- Using the Adaptec RAID Configuration Utility
- Using the Array Configuration Utility for DOS
- Using the Adaptec Flash Utility
- Adaptec Serial Controller LED and I2C Connector Reference
- Adaptec 2420SA Activity LED and I2C Connector Specification
- Adaptec 2820SA Activity LED and I2C Connector Specification
- Adaptec 3085 LED and I2C Connector Specification
- Adaptec 3405 LED and I2C Connector Specification
- Adaptec 3805 LED and I2C Connector Specification
- Adaptec 31205 LED and I2C Connector Specification
- Adaptec 31605 LED and I2C Connector Specification
- Adaptec 4800SAS LED and I2C Connector Specification
- Adaptec 4805SAS LED and I2C Connector Specification
- Safety Information
- Technical Specifications
- Index
Chapter 4: Getting Started ● 33
Selecting Cables
This section describes the cable options and requirements for your Adaptec controller:
● For SAS cables, see this page.
● SATA cables, see page 34.
● SCSI cables, see page 35.
SAS Cables
You need one SAS cable for each disk drive you are connecting to your Adaptec SAS RAID
controller.
Depending on your requirements, you can use any of these cables:
External cable (SFF-8470 to SFF-8470)—Connects to
an external SAS enclosure.
Internal fan-out cable (SFF-8484 to 4x SATA)—Connects
to four internal SATA disk drives.
(SAS-to-SAS fan-out cables—not shown—are also
available.)
External mini-SAS (SFF-8088 to SFF-8470)—Connects
to an external SAS enclosure.
Internal mini-SAS with power (SFF-8087 to SFF-8482)—Connects
to four SAS or SATA disk drives.