User`s guide
Table Of Contents
- About This Guide
- Kit Contents and System Requirements
- About Your RAID Controller
- Standard RAID Controller Features
- Adding Enhanced Features
- Adding a Battery Backup Module
- Upgrading the Controller Firmware
- About the Adaptec 3085
- About the Adaptec 3405
- About the Adaptec 3805
- About the Adaptec 31205
- About the Adaptec 31605
- About the Adaptec 4000
- About the Adaptec 4800SAS
- About the Adaptec 4805SAS
- About the Adaptec 2420SA
- About the Adaptec 2820SA
- About the Adaptec 2130SLP
- About the Adaptec 2230SLP
- Getting Started
- Installing the Controller and Disk Drives
- Creating a Bootable Array
- Installing the Driver and an Operating System
- Installing the Driver on an Existing Operating System
- Managing Your Storage Space
- Solving Problems
- Introduction to Serial Attached SCSI
- Understanding RAID
- Using the Adaptec RAID Configuration Utility
- Using the Array Configuration Utility for DOS
- Using the Adaptec Flash Utility
- Adaptec Serial Controller LED and I2C Connector Reference
- Adaptec 2420SA Activity LED and I2C Connector Specification
- Adaptec 2820SA Activity LED and I2C Connector Specification
- Adaptec 3085 LED and I2C Connector Specification
- Adaptec 3405 LED and I2C Connector Specification
- Adaptec 3805 LED and I2C Connector Specification
- Adaptec 31205 LED and I2C Connector Specification
- Adaptec 31605 LED and I2C Connector Specification
- Adaptec 4800SAS LED and I2C Connector Specification
- Adaptec 4805SAS LED and I2C Connector Specification
- Safety Information
- Technical Specifications
- Index
Chapter 3: About Your RAID Controller ● 28
About the Adaptec 2130SLP
The Adaptec 2130SLP is a low-profile SCSI controller with these features:
Form Factor Low-profile MD2
Bus compatibility PCI-X, 3.3 V
PCI-X bus width 64-bit
PCI-X bus speed 133 MHz
Standard cache 128 MByte embedded DDR memory (optional 256MB)
Connectors Internal = One 68-pin high-density
External = One 68-pin VHDCI
RAID levels 0, 1, 1E, 5, 5EE, 6, 10, 50, 60
Simple volume Yes
Disk drives Up to 15 SCSI devices
Maximum number of disk drives 15
Hot spares Yes
Enclosure Support SAFTE
Automatic Failover Yes
Onboard speaker Yes
Audible Alarm Yes
Battery backup module Adaptec Battery Module 400 (sold separately—see page 17)
1 external VHDCI
SCSI connector
Mounting bracket
1 internal HD SCSI
connector
PCI/PCI-X connector
Battery
connector
Mode 0 Flash connector
Activity LED