User`s guide

3A-32 A-63054 February 2004
Transport time-out action—select an option to determine what takes place
when the transport times out.
•Select End job to stop the transport and feeder and disable the scanner.
Scanning must be reinitiated from Capture Software.
•Select Stop feeder and transport to stop the transport and feeder, and
leave the scanner enabled. Scanning can be reinitiated by pressing the
green button on the scanner operator control panel.
Function keys 1-3—the i800 Series Scanners have three programmable keys
that are accessible from the operator control panel. These keys are available
for use by the operator when the scanner is enabled. The operator control
panel displays the numbers 1 through 3 corresponding to the buttons on the
control panel that represent the function keys.
Each of the programmable keys can be assigned to the following functions:
•Select None for no scanner functionality. This is the default setting.
•Select End Job to stop the feeder and transport and disable the scanner.
Scanning is stopped in Capture Software.
•Select Terminate Batch to terminate the active batch when scanner
batching is enabled. See the i800 Series Scanner options in Chapter 4,
Application Setup.
•Select Skip multi-feed detection on next document to turn off multifeed
detection for the next page scanned.
•Select Skip printing on next document to turn off printing for the next
page scanned.
•Select Skip patch reading on next document to turn off patch code
reading for the next page scanned.