User`s guide

A-63054 February 2004 3A-31
Specific settings for the
i800 Series Scanners
For the i800 Series Scanners, the Scanner Setup dialog box has the specific
settings shown below.
Auto-start transport—allows you to start the scanner transport and feeder
automatically when the Start Scanner button is pressed in the main window of
Capture Software. By default, this setting is enabled. When disabled, the
scanner transport will not automatically start. As a result, you must press the
green button on the scanner operator control panel to initiate scanner feeding.
The following settings will only take effect when at least one page is scanned.
Lamp time-out—when enabled, the lamps in the scanner will automatically
shut off after a specified number of minutes of scanner inactivity. Valid values
are 1 to 30 minutes. When this feature is disabled, the lamps in the scanner
remain on until the scanner is powered off.
Transport time-out—when enabled, the scanner transport and feeder will
automatically stop after a specified number of seconds of no scanning.
Valid values are 5 to 300 seconds. When this feature is disabled, the
scanner transport and feeder remain on until the scanner is disabled in
Capture Software.