User`s guide

A-63054 February 2004 3A-29
Mode Setup The default image address format for each mode in Capture Software matches
the factory setting of the mode defined in the scanner. As a result, you should
only need to make changes in Capture Software if mode changes were made
in your scanner through the KODAK Scanner Mode Setup Software.
To make changes to your mode setting in Capture Software, do the following:
1. Select a Mode from the drop-down list of 18 mode numbers.
2. Enter an optional mode Name that will be displayed in Capture Software
whenever you are selecting a mode to be downloaded to the scanner.
3. Enter the Image address length for each of the image address fields.
The lengths of the image address fields must match the image address
format as defined in the scanner. To assist you in determining what the
lengths should be, click on the Read from scanner button. This will adjust,
if necessary, the image address lengths to match the lengths as defined in
the scanner.
NOTES: The total of all of the image address lengths must not exceed
12 characters.
A length of “0” means that the image address field is not used or it is
not applicable for the selected mode.
Read from scanner is operational only for the Scanner 5500 and
Scanner 7500/7520.