User`s guide

2-8 A-63054 February 2004
- For the i800 Series Scanners, the Auto-start transport option in the
Scanner Setup dialog determines what the Start button does.
When Auto-Start transport is enabled, the scanner transport and feeder
will automatically run and start scanning.
When Auto-Start transport is disabled, the Start button enables only the
scanner. You must press the green button on the scanner control panel to
start the scanner transport/feeder.
It may take a few seconds to start the scanner the first time because
Capture Software is downloading parameters. Successive starts are faster.
To stop the scanner in Capture Software:
• Click the red Stop button on the Scanner bar of the Capture Software main
window or press F6.
NOTE: The i50 Scanner, i60 Scanner, or i80 Scanner will stop when all
documents in the feeder have been scanned.
Exiting Capture Software • To exit Capture Software, select File>Exit.
The Capture Software application closes.
Restarting if a
transport time-out
occurs
The scanner stops automatically when you do not scan documents for a
period of time (based upon the time-out period that is set in the Scanner
Setup dialog box).
To restart the feeder and transport, click the green Start button on the
Scanner bar and continue feeding documents. You do not need to restart
Capture Software.