User`s guide

4-22 A-63054 February 2004
Batch tab The Batch tab allows you to define the batching function that is available in the
i800 Series Scanners.
Click on the Enable check box to enable scanner batching. When enabled the
scanner counts, a specified number of either Level 1, Level 2, or Level 3
pages. In Capture Software, Level 1 pages are referred to as Pages, Level 2
pages are referred to as Documents, and Level 3 pages are referred to as
Batches. When the specified number has been reached, the scanner will
perform an End of batch function. Then the counting starts all over again after
the scanner performs a Start of batch function.
NOTES: Scanner batching does not actually start until the scanner is
enabled within Capture Software and the scanner feeder and
transport are started.
Because scanner batching is based on page levels, it really only
makes sense when image addressing is also defined in scanner.
Batch type—specify the type of batching that is to be performed. Select one of
the following from the drop-down list:
Pages or Level 1 pages scanned.
Documents or Level 2 pages scanned.
Batches or Level 3 pages scanned.
Batch size—specify the number of the Batch type that will be counted by
the scanner to determine the end of a batch. A number from 1 to 32,000 is
allowed. When the scanner is enabled, the Batch size number is displayed on
the scanner operator control panel to indicate to the user that batching has
been enabled.