Specifications

Page 86 DocSTAR Level 2 Service Training Workbook
Section 2: Adding RAID/Two-Tier Storage to a DocSTAR System
? This section will cover basic information about adding RAID/Two-Tier Storage to a
DocSTAR system
After the RAID hardware (and utility software for Internal RAID) is installed DocSTAR
software must be setup to use the Two-Tier storage system incorporating the RAID
device. The following requirements must be met for Two-Tier storage to work:
The system must be running DocSTAR software version 2.33 or higher
The license for Two-Tier storage must be programmed into the Hardware Key
Setting Up Two-Tier Storage to Work with DocSTAR
Two-Tier storage is a process whereby data is written to both an online media (RAID) and
an archive media (Optical Disk). In order for DocSTAR to use Two-Tier storage you must
setup Two-Tier storage in the DocSTAR Administration Program.
Select the ‘Paths’ button from the Administration program, as shown below:
The drive letter, in the Archive path shown above, must correspond to the drive letter of
the optical drive (DVD-RAM or Magneto-Optical drive). Then select the Two-Tier storage
button and you will see the following screen: