Specifications

DocSTAR Level 2 Service Training Workbook Page 79

Note: If you delete an array and later want to restore it, you must use the same

settings in Auto Setup as were used to originally define the array, otherwise you

will lose the data that exists on the drive.

If you select ‘Rebuild Array [5],’ you will be able to select an array to be rebuilt as shown

below:

When a rebuild is necessary, it is best to allow the Windows FastCheck Monitoring Utility

to perform an Automated Rebuild (the customer will not be down while the rebuild is

happening). This can be done by not entering the BIOS utility when an array is showing a

critical status and continue with loading Windows.

Lastly, if you select ‘Controller Configuration [6],’ you will be able to see the current

configuration of the adapter as shown below:

2000 Promise Technol

ogy, Inc.

[ Rebuild Array Menu ]

Array No RAID Mode Total Drv Capacity(MB) Status

* Array 1 Mirror 2 29188 Functional

Array 2 ---- ---- -----

Array 3 ---- ---- -----

Array 4 ---- ---- -----

[ Keys Available ]

[?]Up [?]Down [ESC] Exit [Enter] Select