Specifications

007-4276-001 75
Chapter 4
4. Solving Problems
This chapter helps you identify and solve problems that might occur while you are using
the system.
Resetting the System
Table 4-1 shows the commands used to reset the system.
Initial System Startup
Problems that occur at initial system startup are usually caused by incorrect installation
or configuration. Hardware failure is a less frequent cause. Use the following check list
to troubleshoot Startup problems:
• Are all cables correctly connected and secured?
• Are the processors fully seated in their slots on the baseboard?
• Are all PCI add-in boards fully seated in their slots on the baseboard?
• Are all switch and jumper settings on the baseboard correct?
• Are all jumper and switch settings on add-in boards and peripheral devices correct?
To check these settings, see the manufacturer's documentation. If applicable, ensure
Table 4-1 Resetting Commands
To do this: Press:
Clear system memory, restart POST, and reload the operating
system.
Reset button or <Ctrl+Alt+Del>
Cold boot reset, which clears system memory, restarts POST,
reloads the operating system, and stops power to all peripherals.
Power off/on