Specifications

Memory
007-4276-001 55
X. One of sixteen DIMM sockets
Y. One of four memory address data paths (MADP)
Z. Memory expansion card connector (MECC)
Removing the Memory Module
The memory module is located on the baseboard as shown in Figure 3-1 on page 52. The
DIMM locations are shown in Figure 3-2.
To remove the memory module, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Pullthemoduleupwardslightlytodisengageitfromthebaseboardconnector.
3. Slide the module straight up and away from the baseboard until it clears the guide
rails.
4. Place the module component-side up on a nonconductive, static-free surface.
Installing the Memory Module
To install the memory module, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Holding the memory module by its edges, align the module so its edge engages the
guide rails at the back and front of the electronics bay.
Caution: The memory module is held in place by the 330-pin connector on the
baseboard, the guide rails in the center of the electronics bay. You must support the
module until it is fully seated in the connector.
3. Push the memory module toward the baseboard until it fully engages the connector
on the baseboard.
!