Specifications

46 007-4276-001
2: Removing and Installing System Components
3. Remove the front cover. See “Removing the Front Cover” on page 23.
4. Disconnect the power and signal cables from the back of the drive.
5. Remove and save the screw that secures the drive to the bay. The screw is noted by
“A” in Figure 2-11.
6. Slide the drive out. If the drive will be used again, place it in an antistatic protective
wrapper.
Installing a Drive in the Media Bay
To install a drive in the media bay, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Remove the drive to be replaced according to the instruction in the preceding
subsection.
3. Slide the new drive in the media bay.
4. Connect the power and signal cables to the drive.
5. Insert and tighten the screw that secures the drive to the bay. The screw is noted by
“A” in Figure 2-11.
6. Install the front cover. See “Installing the Front Cover” on page 24.
Replacing a Drive in the Device Bay
To replace a drive in the device bay, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Remove the front cover. See “Removing the Front Cover” on page 23.
3. Turn off the system by pressing the power on/off button on the front panel, and
unplug the AC power cord.
4. Disconnect the power and signal cables from the drive. The connectors are keyed for
ease in reconnecting them to the drive.
5. Slide the drive out. If the drive will be used again, place it in an antistatic protective
wrapper.
6. Slide the new drive into position using the guides in the device bay.