Specifications

44 007-4276-001
2: Removing and Installing System Components
7. With a flat head screwdriver, pry the right side of the hard drive bay out of the
chassis, as shown in Figure 2-10.
Figure 2-10 Removing the Hard Drive Bay from the Chassis
Installing the Hard Drive Bay
To install the hard drive bay, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Slide the hard drive bay into the chassis until the tabs engage the slots on the
chassis.
3. Connect the four cables to the hard drive bay.
4. Install the SCSI hard drives. See “Installing a SCSI Hard Drive” in the SGI 1450
Server User’s Guide.
5. Install the fan board assembly. See “Installing the Fan Board Assembly” on page 40.
6. Install the top cover. See “Installing the Top Cover” on page 25.
7. Install the front cover. See “Installing the Front Cover” on page 24.