Specifications

Baseboard

007-4276-001 31

Installing the Baseboard

To install the baseboard, follow these steps:

1. Observe the safety and ESD precautions at the beginning of this chapter.

2. Pull the E-Bay away from the chassis. As you separate the E-Bay away, make sure

that the power cord does not become wedged between the two parts of the chassis.

3. Hold the baseboard on the side closest to the VRM connectors and processors. Slip

the baseboard under the padding on the right side of the E-Bay and then under the

back panel at the rear of the chassis.

4. Using needlenose pliers, install the plastic rear retention mechanism located at the

front of the E-Bay. The rear retention mechanism is noted by “A” in Figure 2-4.

Figure 2-4 Rear Retention Mechanism

5. Place the rug at the bottom of the E-Bay.

6. SlidetheE-Bayintothechassis.AsyouslidetheE-Bayin,makesurethatthepower

cord does not become wedged between the two parts of the chassis.

7. Attach the four screws on the top and bottom edges of the rear subchassis. See

Figure 2-3 on page 30.