Specifications

30 007-4276-001
2: Removing and Installing System Components
18. Remove the plastic slot dividers. First, pull up on the end at the front of the E-Bay,
and then slide the other end out of the back panel at the back of the E-Bay.
19. Removethescrewssecuringthebaseboardtothechassis.Thereshouldbetwoof
them.
20. Remove the four screws on the top and bottom edges of the rear subchassis. These
screws attach the E-Bay to the chassis. Two of the four screws are noted as “A” in
Figure 2-3.
Figure 2-3 E-Bay Retaining Screws
21. Pull the E-Bay away from the chassis. As you separate the E-Bay away, make sure
that the power cord does not become wedged between the two parts of the chassis.
22. Remove the rug from the E-Bay.
23. Using needlenose pliers, remove the plastic rear retention mechanism located at the
front of the E-Bay. The rear retention mechanism is noted by “A” in Figure 2-4 on
page 31.
24. Slidethebaseboardtowardsthefrontofthechassis.
25. Lift the baseboard up and out on the side closest to the baseboard and VRM
connectors.
A