Specifications

26 007-4276-001
2: Removing and Installing System Components
4. Position the cover over the chassis so that the rows of tabs align with slots in the
chassis. Slide the cover toward the front of the system until the tabs on the cover
firmly engage in the chassis.
5. Attach the cover to the chassis with the two thumbscrews released earlier, and
tighten them firmly.
6. Connect any external cables.
Memory Retention Bar
When accessing baseboard components, you need to remove and install the memory
retention bar.
Removing the Memory Retention Bar
To remove the memory retention bar, follow these steps:
1. Unscrew the captive screw located at the front of the E-Bay. The captive screw is
noted by “A” in Figure 2-1.
2. LiftupthebarfromthesidelocatedatthefrontoftheE-Bay.
3. Release the clip located at the rear of the chassis. The clip is noted by “C” in
Figure 2-1.