Specifications

24 007-4276-001
2: Removing and Installing System Components
• Removing and installing media devices in the device bay
• Removing and installing the fan board assembly
• Removing and installing the power subsystem bay
• Removing and installing a power supply module (front bezel only)
To remove the front cover, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Remove the front bezel by gently pulling it towards you. The ball studs will release
from the chassis.
3. Remove the three screws located on the top of the chassis. These screws are noted by
“A” in Figure 1-2 on page 4. Save these screws; you need them later to reattach the
cover.
4. Using an even pull and pressing down, slide the cover back towards the front of the
chassis about 0.75 inch.
5. Lift the front cover up and out of the chassis.
Installing the Front Cover
To install the front cover, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Before replacing the front cover, check that no loose tools or parts were left inside
the system.
3. Check that cables and other components are properly installed.
4. Position the cover over the chassis so that the rows of tabs align with slots in the
chassis. Slide the cover toward the back of the system until the tabs on the cover
firmly engage in the chassis.
5. Attach the cover to the chassis with the three screws removed earlier, and tighten
them firmly.
6. Install the bezel by gently applying pressure towards the chassis. The ball studs
snap into the chassis.