Specifications

8 007-4276-001
1: Detailed Chassis Description
E. Electronics Bay
(E-Bay)
The E-Bay contains the baseboard. The baseboard has the following
major components:
Up to four Intel® Pentium® III Xeon™ processors
Server Set™ III HE chipset
Up to sixteen PC/100-compliant registered ECC SDRAM memory
modules that support up to 16 gigabytes of Error Checking and
Correcting (ECC) Synchronous Dynamic RAM
32-bit, 33-MHz, 5V PCI segment with two expansion slots and three
embedded devices
64-bit, 66/33-MHz, 3.3V hot-plug PCI segment with two expansion
slots and one embedded device
64-bit, 33-MHz, 5V hot-plug PCI segment with four expansion slots
and three embedded devices
Compatibility bus segment with three embedded devices
Two externally accessible USB ports
One IDE connector, supporting up to two ATA33 compatible devices
One Adaptec® AIC-7880 SCSI controller
One Adaptec AIC-7899 SCSI controller
The processors, SDRAM memory modules, and hot-plug PCI
components are listed individually below.
E1. Processors The system supports up to four Intel Pentium III Xeon processors.
E2. Registered SDRAM
Memory Expansion
Slots
The memory expansion board holds up to sixteen Dual Inline
Memory Module (DIMM) slots and supports up to 16 gigabytes of
Error Checking and Correcting (ECC) Synchronous Dynamic RAM.
E3. PCI Add-In Slots The baseboard contains two 32-bit 33-MHz non-hot-plug PCI slots.
These boards are half-length boards only.
E4. PCI Hot-Plug Slots The baseboard contains six hot-plug PCI slots. You can add, remove,
or exchange a PCI add-in board from any hot-plug slot without
shutting down the server.
NOTE: At this time, the Linux® operating system does not
support use of the PCI hot-plug (PHP) feature. If you are running
Linux, your system must be turned off before installing or
removing PCI boards. Windows 2000 requires drivers that are
PHP compatible in order to use the PHP feature.
Table 1-2 (continued) Chassis Feature Summary
Feature Description