User`s manual

Chapter 5: Running Setup
5-19
H/W Monitor In0 (CPU 1)
H/W Monitor In1 (CPU 2)
H/W Monitor In2 (+3.3V)
H/W Monitor In3 (+5V)
H/W Monitor In4 (+12V)
H/W Monitor In5 (-12V)
H/W Monitor In6 (-5V)
CPU1 Fan
CPU2 Fan
Thermal Control Fan
The above features are for PC Health Monitoring. The motherboards with
W83781D have seven on-board voltage monitors for the CPU core, CPU I/
O, +3.3V, +5V, -5V, +12V, and -12V, and three fan status monitors.
On-Board FDC
This option enables the FDC (Floppy Drive Controller) on the motherboard.
The settings are Auto (AMIBIOS automatically determines if the floppy
controller should be enabled), Disabled , or Enabled .
On-Board Serial Port 1
This option specifies the base I/O port address of serial port 1. The
settings are Auto (AMIBIOS automatically determines the correct base I/O
port address), Disabled , 3F8h/ COM1, 2F8h/COM2 , 3E8h/COM3 or 2E8h/
COM4 .
On-Board Serial Port 2
This option specifies the base I/O port address of serial port 2. The
settings are Auto (AMIBIOS automatically determines the correct base I/O
port address), Disabled , 3F8h/COM1 , 2F8h/COM2 , 3E8h/COM3 or 2E8h/
COM4 .
Serial Port 2 Mode
The settings for this option are Normal, IrDA or ASK IR . When set to
IrDA, the IR Duplex Mode becomes available and can be set to either Half
or Full. When set to ASK IR, the IrDA Protocol becomes available and
can be set to 1.6 us or 3/16.
On-Board Parallel Port
This option specifies the base I/O port address of the parallel port on the
motherboard. The settings are Auto (AMIBIOS automatically determines
the correct base I/O port address), Disabled , 378 , 278 or 3BC .