User`s manual

Chapter 5: Running Setup
5-15
no display activity for the length of time specified in the Standby Timeout
(Minute) option, the computer enters a power savings state. The settings
are Monitor or Ignore .
Device 6 (Serial port 1)
Device 7 (Serial port 2)
Device 8 (Parallel port)
Device 5 (Floppy disk)
Device 0 (Primary Master IDE)
Device 1 (Primary Slave IDE)
Device 2 (Secondary Master IDE)
Device 3 (Secondary Slave IDE)
When set to Monitor , these options enable event monitoring on the
specified hardware interrupt request line. If set to Monitor and the
computer is in a power saving state, AMIBIOS watches for activity on the
specifies IRQ line. The computer enters the Full On state if any activity
occurs. AMIBIOS reloads the Standby and Suspend timeout timers if
activity occurs on the specified IRQ line. Note: The Optimal default
setting for each option is Ignore with the exception of Devices 0
(Primary Master IDE) and 6 (Serial Port 1) which should be set to
Monitor. The Fail-Safe default for each option is Monitor.
LAN Wake-Up
RTC Wake-UP
Options for LAN Wake-Up and RTC Wake-Up are Disabled or Enabled .
When enabled, the Hour and Minute functions become available.
5-1-5 PCI/PnP Setup
Plug and Play-Aware OS
The settings for this option are No or Yes . Set this option to Yes if the
operating system in the computer is aware of and follows the Plug and
Play specification. AMIBIOS only detects and enables PnP ISA adapter
cards that are required for system boot. Currently, only Windows 95 is
PnP-Aware. Set this option to No if the operating system (such as DOS,
OS/2, Windows 3.x) does not use PnP. You must set this option cor-
rectly. Otherwise, PnP-aware adapter cards installed in the computer will
not be configured properly.
PCI Latency Timer (PCI Clocks)
This option specifies the latency timings in PCI clocks for all PCI devices.
The settings are 32 , 64 , 96 , 128 , 160 , 192 , 224 , or 248 .