User`s manual

Chapter 5: Running Setup
5-1
Chapter 5
Running Setup*
*Optimal and Fail-Safe default settings are bolded in text unless otherwise
noted.
The WinBIOS Setup options described in this section are selected by
choosing the appropriate high-level icon from the Standard Setup screen.
All displayed icons are described in this section, although the screen
display is often all you need to understand how to set the options.
5-1 Setup
5-1-1 Standard Setup
Pri Master
Pri Slave
Sec Master
Sec Slave
Select these options to configure the drive named in the option. Select
Auto Detect IDE to let AMIBIOS automatically configure the drive. A
screen with a list of drive parameters appears. Click on OK to configure
the drive.
Type How to Configure
SCSI Select Type . Select Not Installed on the drive parameter
screen. The SCSI drivers provided by the SCSI manufac
turer should allow you to configure the SCSI drive.
IDE Select Type . Select Auto to let AMIBIOS determine the
parameters. Click on OK when AMIBIOS displays the drive
parameters. Select LBA Mode . Select On if the drive has
a capacity greater than 540 MB. Select the Block Mode .
Select On to allow block mode data transfers. Select the
32-bit mode . Select On to allow 32-bit data transfers.
Select PIO mode . Select On to allow AMIBIOS to deter
mine the PIO Mode. It is best to select Auto to allow
AMIBIOS to determine the PIO mode. If you select a PIO
mode that is not supported by the IDE drive, the drive will