User`s manual

SUPER P6DGS/P6DGE/P6DGU/P6SGU Manual
2-8
PW_ON Connector
The PW_ON connector is located
on pins 9 and 10 of JF2. Momen-
tarily contacting both pins will
power on/off the system. The
user can also configure this but-
ton to function as a suspend but-
ton. (See BIOS setup information
on page 5-13). To turn off the
power when set to suspend mode,
hold down the power button for at
least 4 seconds. See Table 2-5
for pin definitions.
Reset Connector
The reset connector is located on
pins 12 and 13 of JF2. This con-
nector attaches to the hardware
Reset switch on the computer
case. See Table 2-6 for pin defi-
nitions.
Pin
Number
9
10
Definition
PW_ON
Ground
Table 2-5
PW-ON Connector
Pin Definitions
(JF2)
Table 2-7
Hard Drive LED
Pin Definitions
(JF1)
Pin
Number
1
2
3
4
Definition
+5V
HD Active
HD Active
+5V
Pin
Number
12
13
Definition
Ground
Reset
Table 2-6
Reset Connector
Pin Definitions
(JF2)
Hard Drive LED
The hard drive LED is located on
pins 1 to 4 of JF1. Attach the hard
drive LED cable onto pins 1 and 2.
See Table 2-7 for pin definitions.
Keylock/Power LED
Connector
The keylock/power LED connector
is located on pins 5 to 9 of JF1.
See Table 2-8 for pin definitions.
Pins 5 and 7 are for the power
LED. Pins 8 and 9 are for the
keylock.
Pin
Number
5
6
7
8
9
Function
VCC +5V
VCC +5V
Ground
Ground
Table 2-8
Keylock/Power LED Connector
Pin Definitions
(JF1)
Definition
Red wire, LED power
Red wire, LED power
LED control
Keyboard inhibit
Black wire