User`s manual

SUPER P6DGS/P6DGE/P6DGU/P6SGU Manual
2-2
2. Install the Universal Retention Mechanism (URM) under the mother-
board. Do this before mounting the motherboard into the chassis. Do not
screw too tightly. Mount the two black plastic pegs onto the motherboard
(Figure 2.1). These pegs will be used to attach the fan heatsink supports.
Notice that one hole and the base of one peg are larger than the other hole
and peg base. Push each peg into its hole firmly until you hear it "click" into
place.
Figure 2-1. Mounting the Pegs
Universal Retention
Mechanism
Large peg and hole
3. Slide a black plastic support onto each end of the fan heatsink, making
sure that the hole and clip are on the outside edge of the support. If the supports
are reversed, the holes will not line up with the pegs on the motherboard. Slide
each support toward the center of the processor until the support is seated in the
outside groove in the fan housing.
4. Slide the clip (A) on each support toward the processor, exposing the hole
that will fit over the peg on the motherboard. Push the latches (B) on the
processor toward the center of the processor until they click into place.
5. Hold the processor so that the fan shroud is facing toward the pegs on the
motherboard. Slide the processor (C in Figure 2-2) into the retention mechanism
and slide the supports onto the pegs. Ensure that the pegs on the motherboard