User`s manual

Chapter 1: Introduction

1-11

Features of the P6DGS, P6DGE, P6DGU and P6SGU

The following list covers the general features of the SUPER P6DGS, P6DGE,

P6DGU and P6SGU.

CPU

• Single or dual Pentium II 233/266/300/333 MHz processors at 66 MHz

bus speed or Pentium II/III 350/400/450/500/550/600/650/700 MHz

processors at 100 MHz bus speed (The P6SGU supports only a single Pentium II/

III processor.) Note: Please refer to the support section of our web site for a complete listing

of supported processors. (http://www.supermicro.com/TechSupport.htm)

Memory

• 2 GB unbuffered 3.3V SDRAM or 2 GB registered SDRAM

(Note: When the CPU bus is running at 100 MHz, the SDRAM must be PC-100 compliant

DIMMs.)

(Note: The maximum cacheable memory size depends on processor capabilities.)

• ECC (Error Checking and Correction), non-ECC and Error Checking

supported

Chipset

• Intel 440GX

Expansion Slots

P6DGS/P6SGU P6DGU/P6DGE

• 4 PCI slots • 5 PCI slots

• 3 ISA slots • 2 ISA slots

[one PCI/ISA shared slot] [one PCI/ISA shared slot]

• 1 AGP slot • 1 AGP slot

BIOS

• 2 Mb AMI

Flash BIOS

• APM 1.2, DMI 2.01, Plug and Play (PnP)

• Adaptec 7890 SCSI BIOS (P6DGU/P6SGU only)

• Adaptec 7895 SCSI BIOS (P6DGS only)

PC Health Monitoring

• Seven onboard voltage monitors for CPU core(s), CPU I/O, +3.3V, ±5V,

and ±12V

• Three fans status monitor with firmware/software on/off control

• Environmental temperature monitor and control

• CPU fan auto-off in sleep mode

• Chassis overheat alarm, LED, and control

• Chassis intrusion detection

• System resource alert